Most 2025 and 2026 price guides put recessed lighting in an existing ceiling at about $150 to $350 per light. A typical six-light room comes to roughly $1,000 to $3,000, and some guides add dimmers or ceiling repair on top. These are national guide figures, not Stockton prices, and a local electrician's own quote is what counts. This guide breaks the number down. It sits within our guide to lighting, fans and fixtures.
How much does recessed lighting installation cost per light?
Expect about $150 to $350 per light for installation in an existing ceiling, with a closed ceiling or finished floor above running higher. The price includes the light, cable, a share of the electrician's time and basic materials. Easy access above the ceiling brings it down. A finished floor above, plaster or a vaulted ceiling brings it up.
| Item | Typical range in national price guides |
|---|---|
| One recessed light, existing ceiling | $150 to $350 |
| Six lights in one room | about $1,000 to $3,000 |
| LED retrofit kit for an existing can, kit only | $20 to $75 each |
| Electrician hourly rate | about $50 to $130 |
| Permit, where required | set by city and scope |
One guide puts a new light under a finished floor or in a closed ceiling at $250 to $500 or more. Treat the higher numbers as the cost of complicated jobs, not as the normal case.
What drives the cost of recessed lighting?
The biggest factors are access above the ceiling, the number of lights, the length of the cable run, ceiling type, dimmers and whether a new circuit is needed. A first light costs more than the fifth, because the electrician has to bring power from the switch once and then reuse that path. Routing around joists and ducts adds time.
Check these in your own room:
- Attic access. An attic above the room usually lowers labor per light.
- Obstacles. Ducts, pipes and beams can add to a light's cost when cable has to be routed around them.
- Ceiling type. Drywall is simple. Plaster, tile and vaulted ceilings take more care.
- Dimmers. An LED rated dimmer is often a separate line on the quote.
- New circuit. If the existing circuit is full, a new one costs more, and the permit rises.
- Insulation rating. Lights rated for insulation contact cost a bit more than basic ones.
Fixtures are the small part. Most of the price is labor and wire runs. So paying more for a nicer light changes the total less than adding extra lights does.
How much does it cost to install recessed lighting in an existing ceiling?
National price guides give about $150 to $350 per light, or roughly $1,000 to $3,000 for a six-light room. The jump from the per-light figure to the room total comes from dimmers, a switch change and patching. Cost is lower when the electrician can work from an attic. It is higher when drywall must be opened.
Here is how a six-light room can add up in a typical case: lights and labor for six openings, one dimmer, a small amount of drywall patching and, if needed, a permit. Without a site visit, a quote is a guess, so ask the electrician to look at the attic or the space above and measure the room.
For how the work actually goes, read how to install recessed lighting. That page covers canless lights, drop ceilings and what DIY involves.
How much do canless and outdoor lights cost to install?
Canless (wafer) LED lights are often a bit cheaper in labor than can-style lights, because they need less space above the ceiling and install faster. The light modules are inexpensive. Outdoor light fixtures cost more per light because of weather rated boxes, sealing and the cable run outside. Prices vary by case, so use a quote.
Outdoor work needs cable and fittings made for wet locations. If you are adding lights under eaves or in a soffit, ask the electrician what the quote includes for weatherproofing. The price for outdoor fixtures in national price guides is generally above indoor retrofit work, and it rises with the distance from power.
How much does it cost to rewire a chandelier?
Rewiring a chandelier is usually priced as a job and not by the light, and it depends on the fixture. Some are simple, with new cord and sockets. Antique or large pieces take more time. A local electrician can often quote after seeing a photo, but a heavy fixture also needs a ceiling box that can carry its weight.
Ask whether the quote covers removing and rehanging the fixture, and whether the ceiling box is checked. A chandelier is held by the box and chain, so a weak box is a hazard, not an inconvenience. This is separate from the cost of putting in recessed lights, but the same electrician can often do both in one visit.
How do I compare recessed lighting quotes?
Ask each electrician for the same scope: number of lights, type of light, dimmer, patching and permit. Compare the price per light and the total, and check whether each quote lists what is excluded. A very low quote often leaves out patching or the permit. Ask who holds the C-10 electrical license for the job.
A good quote lists lights, labor, materials, permit and cleanup separately, so you can see where each price differs. For a longer checklist see how to choose an electrician, and for ceiling fan pricing see ceiling fan installation cost. California law requires a C-10 contractor for work done for others when labor and materials reach $1,000, or when a permit or hired workers are involved, and a room of lights will usually pass that mark.
Questions people ask
How long does recessed lighting installation take?
One light on an easy run may take a couple of hours. A room of four to six lights usually takes most of a day, and longer if the ceiling is finished above or the wiring is old. National price guides often use about two and a half hours per light as a rule of thumb.
What should I ask before I hire someone for recessed lighting installation?
Ask what the price includes: lights, dimmer, patching, permit and cleanup. Ask who holds the C-10 electrical license, how many lights the circuit can carry and what happens if the electrician finds old wiring. Get the quote in writing and compare at least two.
Do I need to be home for recessed lighting installation?
Usually yes, at the start and the end. The electrician needs to walk the rooms, agree where the lights go and show you the finished work. Plan for part of the house to be without power for some of the day, and clear the furniture under the work area.
Is it cheaper to put in recessed lights in new construction?
Yes, usually. When the ceiling is open, an electrician can fix housings to the joists and run cable without cutting drywall. Existing ceilings need holes and cable fished through, and that takes more time. If you are planning a remodel, ask for lights to be priced while the ceiling is open.
Do recessed lights raise my electric bill?
Not much. LED recessed lights use little power, and fewer watts per light means a room of them costs only a small amount a month to run. Old halogen cans used far more. If you replace old cans with LED modules, your bill can go down.
If you want prices for your own ceiling, ask local electricians in Stockton to quote the job.
Sources used
Last changed